Master Shaper Series II - Jim Phillips

Well, here it is. The final entry in the Master Series - the Master Shaper II.

The Master Shaper Series II DVD - (NTSC)
Running Time: Approx 120 Minutes (2 hrs)
Available W/C 13/02/06.

The focus of this video is shortboard shaping although we did make sure to include many of the intermediate topics not covered in the first shaper video. This DVD has a much faster pace than the previous two but no less information. There is a lot of ground covered in this disk so it may take a few viewings to get it all down. In contrast to the original Master Shaper Series, this new addition focuses on the modern shortboard. Also included in this DVD is an in-depth look at wooden boards. Check right for a detailed list of contents.

Here are the main topics covered in the shortboard sequences:
- Tools (with some new additions)
- Very detailed look at the prep sequence
- How to compensate for blank discrepancies
- Plan shape
- Shaping
- Sanding
- Blank detailing
- Finishing work
- Template making
- Rocker templates
- Spin templates
- Pulling templates off existing boards
- Fin placement explained
- A comparison of the different rocker measurement procedures

Here are the main topics covered in the balsa sequences:
- Cleaning up the raw materials (balsa block)
- Determine and draw rocker
- Tool settings and jigs
- Cut rocker
- Cut redwoood stringers
- Glue up blank
- Layout plan shape
- Shape the blank
- Sanding
- Finishing
- Chambering explanation
- Chamber tools and jigs